Factory wear PU nylon coated glovesPrecautions:
1. Every worker who comes into contact with precision products is required to wear a corded anti-static wrist
2. To ensure that the anti-static wrist effectively removes static electricity, the technicians should test the quality of the anti-static wrist every 3-5 hours
3. For precision board products, anti-static bags or anti-static boxes should be used
4. For mobile vehicles carrying components, use conductive soft rubber to connect the power
5. Mop the floor at least once a day
6. For employees with high static electricity, no matter how good the anti-static wrist is, it will not have any effect on them. Generally, in this case, it is because the employee's skin is relatively dry. You can ask him to wash his hands or ask the supervisor to change his workstation
7. Power supplies, instruments, etc. must be grounded, especially soldering irons. If it is a constant temperature soldering iron, pay attention to grounding, because many factories do not ground it. Some foreign soldering irons do not have grounding inside, which means that the soldering iron is fake. At this time, the voltage can be measured to be more than 70V
8. Some factories have air conditioners and electric fans installed in their production workshops, which will cause a lot of static electricity on employees. This is because the air conditioner has wind and the water evaporates quickly. At this time, the distance between the workstations can be adjusted.
9. There is a wet cloth on the production line
12px;">10. Anti-static and anti-static products, such as ion fans, ion wind rods and other anti-static products, should be used on the workbench of employees and grounded
12. The static electricity in winter will be relatively large, and it is also different on rainy days
13. It is also different when working overtime at night. A wet cloth should be added at the entrance of the workshop for employees to step on before entering the production line
